Treatment of parts overheating of Raymond Mill

smilewei

The main supporting operation of Raymond mill accessories bearing, bearing is the key factor influencing the Raymond mill equipment performance and production efficiency of Raymond mill, the user must pay special attention to the noise of Raymond mill bearing temperature and bearing, in order to avoid the abnormal phenomenon, affecting the normal operation of the machine.
1, too much or too little oil will cause bearing fever phenomenon, overheating, the cooling performance is not good, the heat can not be timely sent out; and too little will not fully lubricated bearing, in the high-speed operation, the bearings will be hot, add oil to bearing lubricating oil, generally about 70% space is good, too much or too little is not conducive to the bearing cooling.
2, the bearing height, or the rotor and mill motor are not concentric, will cause the bearing with additional impact, resulting in bearing overheating. If appear this kind of phenomenon, should immediately adjust the position of the bearing, to avoid the location is not concentric, cause partial grinding phenomenon.
3, Raymond mill bearing and bearing fit too tight, the bearing and the bearing seat can lead to increased wear too tight, too loose would lead to bearing overheating, this problem, we must adjust the bearing and the bearing seat tightness, re-match.